DRILLMATE - PORTABLE DRILL PRESS

HOME



COMPANY
PROFILE



PRODUCTS



MINI
BROACH
CUTTERS



CONTACT
FORM

Drillmate DM100
- The lightweight portable drill press. Weighing just 1.6kg (3˝lbs). Drillmate adds little weight to your portable power drill (Electric or Air), but gives you the power to do the job Ergonomically, Safely and Productively.

Drillmate with its 14:1 force ratio ensures the correct feed force is applied to the drill bit/cutter being used. With your correct selection of power drill speed to suit material and drill bit/cutter size, holes will be produced with reduced operator effort, increased operator safety and efficiency.

Snap On Drill with Portable Drill Press

 
ERGONOMIC
Ergonomically Drillmate allows for an easy stance to be taken and with the increased force ratio of 14, reduced operator effort (and thus fatigue) results. The direction of force application is easier to apply, and with the reaction to the feed force being taken by the leg of Drillmate behind the workpiece, this effect is not overloading the operator's body. (Especially the back and arms.)

SAFETY
Safely Drillmate ensures that both hands are employed. In the drilling/cutting operation; this means that should the drill bit/cutter grab, both hands are taking the sudden load - not just one hand and arm. With both hands employed, this ensures that both hands are clear of rotating parts. Easy stance when drilling ensured back strain does not occur, or the likelihood is greatly reduced.

Safety when drilling overhead or elevated.

PRODUCTIVETY
Productively Sharpness of drill/cutter, correct speed to suit size hole being drilled, material being drilled and feed force all determine rate of hole production and life of drill/cutter. Drillmate ensures correct feed pressure is applied. The even feed force also increases life of drill bit/cutter - up to 1,000 holes through 6.0mm (1/4") mild steel plate without resharpening. Holes are generally straighter (perpendicular to work surface) than achieved by hand.


STANDARD ACCESSORIES

Channel Adaptor - A 100mm (4") long stem which allows the leg of Drillmate to go around the channel or "I" beam flanges for drilling of the main web. (Truck chassis and roof purlins also.)

Vee Block - An adaptor for drilling pipes or round material up to 65mm (2˝") diameter. The top of this Vee Block allows for a 5 degree taper - which is often found on flanges of channels, and makes it easier to drill square to the outside flange.




Vacuum Clamp Drillmate Vac Force Evergreen Mini Broach Cutters Other Products

DRILLMATE PTY LTD
17 Gatwick Road
North Bayswater 3153
VICTORIA AUSTRALIA
Phone:(+613) 9729 9877
Fax:(+613) 9720 5465